A simple way to start a fire in the snow outside the news

starting the fire

Wintertime is the most difficult time to survive. The combination of weather and the lack of easily accessible food caused that many abundant soul have lost their lives for years. Preparation and care are necessary for survival.

If there has ever been a time when you need a fire, then when you do outside in the snow. As the darkness falls, the temperature can fall abruptly, leaving you feel like you are sitting in an ice box. Without a fire, this can lead to a very dangerous situation, which can cost the loss of some fingers and fingers at the feet to frostbite and even loss of life.

Starting a fire can be particularly difficult in the cold of winter. The only more difficult is that trying to do it in the middle of a storm. There are two basic problems in the snow. First of all, snow melted by fire turns into water, which can extinguish your flames and hard work. Secondly, it is warm, not a flame that causes fuel. In cold winter, you must actually raise the fuel temperature to make it light. This can make the fire start slower than usual.

Page selection

The first thing to consider while starting a fire in the snow is a page. The fire must be located in a place where it is protected against snow, as well as against wind and water. Often, people traveling in the desert like to start fire under the tree. This may not work if the tree has a heavy snow load. Warm air from the fire can cause the snow to soften and fall from tree to fire.

An amazing breakthrough in a compact portable backup power – it easily fits in a pocket or backpack!

If you decide to start a fire under the tree, first reach and throw snow from the branch over the fire. This eliminates the risk and does not succeed that you have to delete the same page twice.

When you do this, start removing snow from the real side. You can tear the snow or get tired of it by walking. If you are going to embrace him, realize that it will melt, so you want to make sure that water can run out of the site.

Building a fireplace

I really believe in placing in a stone floor for my fire as soon as fire in rain or snow. Raising fuel by inch or two above the ground and sit on the stones, I provide water channels to escape. Never put off stones when they do it, but leave a small space between them.

When building a fire in the snow, you need a good heat reflector. After all, the main purpose of building a fire is to keep heat. Adding a strong heat reflector will help a lot in this. A large tree, a cliff face or a large stone can act as a thermal reflection. You can also make one of the rescue blankets using the silver side to give the most reflection.

starting the fire

Clean a place for applying additional heating wood also near the fire. If possible, raise this area also on the rocks. If not, use a few cross sticks to keep the wood in front of the snow. Every wood you find will probably accumulate some snow, so a close pile of heating wood gives you a chance to dry wood before it has to use it.

Building fire

You will want to build your fire in a normal way using Tinder, kindling and fuel. When collecting fuel, try to collect large pieces or sections of the trunk or pieces of the tree trunk. These will be particularly good to keep the fire at night and help in maintaining heat. Collect extra wood because you pass through it faster than usual.

If your Tinder and kindles are dry, you should not have major problems with starting fire, although it may turn out that it lasts longer than usual. Remember: you need to add more heat than normal to Tinder to bring it to burning temperatures.

I am deeply convinced in starting fires with one match or one use of my metal match. Basically, I try to force it so that I know that I can always start fire in the worst circumstances. However, when it is rainy or snowy, I don’t mind using acceleration if I can’t start fire immediately.

Cotton balls soaked with oil jelly are my favorite acceleration of fire. In fact, instead of cotton balls, I usually use rounds of cotton makeup removal. They usually stick together when I work in little oil. Although most people use the back of a spoon to work with oil jelly, I discovered that I can do better with my fingers.

As much as possible from the fire

You want to make sure that your shelter and fire are very close to each other. As far as possible, build a fire straight in the entrance to the tent or other shelter, always trying to make anything flammable or which may melt, get closer to the fire. Rescue blankets at the back and roof of the shelter can help keep heat from fire in the shelter, keeping warmer. I always travel with a few of them to be able to capture heat in this way. You also want to make sure you have one among yourself and the earth.

Warm up on fire and use them to heat the bed in front of the entrance. The heated rock can also be wrapped in a spare sleeping sweater as a radiator in bed. Although the rocks are not the most convenient companion of the bed, you will like it warmly.

Carbides are the most important part of every fire because they generate the most heat. Add fuel to your fire so that it can be burned and converted into charcoal. At this point, it will produce the most heat he can. This is much more important than shooting from fire.

Carbides from the fire can be moved by using them to heat the soil under the bed. Use sticks or camp blade to move them to the place where you go to sleep, and then back to your bonfire when they heat the ground.

What are your tips on starting a fire in the snow? Share them in the section below: